Navštíveno 226x
04.10.2005, 23:47 |
Maroš Prodam nove, zabalene 16cm komponenty DLS MS6, plna zaruka, cena dohodou.
mjaniga@gmail.com, 776-285054
06.10.2005, 12:12 |
noname |
editace hodil som ju do mailu. Maros
06.10.2005, 12:37 |
Pavel02 | Upraveno: 2005-10-06 21:14:38
pošli cenu i na můj slovmad@post.cz
06.10.2005, 12:45 |
noname |
editace jaka je cena? a důvod prodeje? kdyz jsou jeste zabalene a co zaruka? jirka.m@centrum.cz
06.10.2005, 13:10 |
noname |
editace jaka je cena? a důvod prodeje? kdyz jsou jeste zabalene a co zaruka? jirka.m@centrum.cz
07.10.2005, 09:39 |
Maroš Reproduktory som kupil asi pred 6 tyzdnami, takze odvtedy plati zaruka.
Rozhodol som sa pre inu variantu ozvucenia zadnej casti auta, preto ich predavam- potrebuju svoj objem aby hrali, a nechcem prist o kufor. Kupoval som ich potom, co som osadil tie iste do prednych dveri... zatial pocuvam iba tie vpredu a staci to, vykonovo aj zvukovo.
Mam tie iste vo vytlmenych prednych dverach svojej Oktavky na MDF podlozkach, hraju uzasne, vela ludi mi povedalo ze nieco take dobre v aute este nepoculi. Maju nadherne a vcelku silne kickbasy, rezem ich na 50 Hz a znie to uzasne...
07.10.2005, 09:42 |
Maroš Pavel02: poslal som maila, no nebol doruceny:
slovmad@post.cz on 10/7/2005 9:41 AM
The e-mail system was unable to deliver the message, but did not report a specific reason. Check the address and try again. If it still fails, contact your system administrator.
< relay2.post.cz #5.0.0 X-Postfix; host mailnfs1.post.cz[212.20.96.218] said: 552 Requested mail action aborted: user's mailbox is full (in reply to end of DATA command)>
07.10.2005, 12:14 |
Maroš Pavel02: poslal som maila, no nebol doruceny:
slovmad@post.cz on 10/7/2005 9:41 AM
The e-mail system was unable to deliver the message, but did not report a specific reason. Check the address and try again. If it still fails, contact your system administrator.
< relay2.post.cz #5.0.0 X-Postfix; host mailnfs1.post.cz[212.20.96.218] said: 552 Requested mail action aborted: user's mailbox is full (in reply to end of DATA command)>
